Waterpik Sensonic Professional Plus SR-3000 Manual page 12

12
CARE OF YOUR WATERPIK® SENSONIC® PROFESSIONAL PLUS TOOTHBRUSH
Battery Removal
The rechargeable battery inside the toothbrush cannot be replaced but can be removed for recycling. Remove
the battery only at the end of the product's life. Doing so earlier will destroy the product. Deplete the battery
charge by running 2 minute cycles until the brush no longer operates. Observe basic safety precautions.
At the end of the product's useful life, open the handle as shown, remove the batteries and dispose of them
according to local regulations. The rest of the product can be discarded per local regulations.
1. Use coin or washer to rotate cap counter
clockwise until cap protrudes. Rotation will
stop at this point.
2. Push down hard with shaft on hard surface.
Note: This process is not reversible
3. Remove cap and pull internal body out.
Cut tape and remove.
4. Lift battery pack up and cut electrical wires,
one at a time, to free from circuit board.
tape