English - Braun Exact Power EP 100 Manual

English

Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Important
• Do not use the trimmer near or over basins filled with water
(e.g. bath tubs, showers etc.).
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace it
if necessary.
Description
1 Distance comb
2 Pivoting twin cutter system
a beard trimmer
b contour trimmer
c release buttons
3 Speed selector
Technical specifications
Power supply: 100 – 240 V
Wattage: 4
Charging your beard trimmer for cordless operation
• For the first 3 chargings: Connect the trimmer to the mains with the on/
off switch on position «0» and charge it for at least 4 hours. The pilot light
indicates that the trimmer is connected to the mains. When the
rechargeable battery is fully charged, the pilot light will noticeably
weaken. If later on, the pilot light comes on again, this indicates that the
trimmer is being recharged to maintain its full capacity.
• Once the trimmer is completely charged, use it without the cord until
discharged.
• Then recharge to full capacity again (subsequent charges will take about
1 hour).
• A full charge will give up to 30 minutes of cordless trimming depending
on your beard. However, the maximum capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for charging is 15 °C to 35 °C.
4 On/off switch
with beard length selector
5 Memory switch
(for 6 beard length settings)
6 Pilot light
/ 50 or 60 Hz (automatic adaptation)
2
7