7 P-Ex OTR opis functions
7.1 Front Side
P-Ex OTR opis 100
7.2 Status LED
POWER:
RX loss*:
TX fault*:
7.3 Data Lines
You must only use pre-fabricated cables to connect data lines to the fiber-optic cable ports.
Ensure that the device is switched off while the cables are being connected. Please observe
the specifications for the fiber-optic cables indicated in section 5.1.2 "Data Lines".
Note: Do not create a port-to-port connection on the devices, as this may damage the devic-
es.
7.4 Troubleshooting
•
Ensure that the POWER LED is on
•
Ensure that the correct power supply has been established for the chosen model.
Note: The start-up current may be twice as great as the operating current!
•
Check the wiring between both ports at the P-Ex OTR opis 1000-SM10 a link failure
is indicated by the orange RX loss LED.
7.5 Support
E-mail:
Telephone:
Page | 25
P-Ex OTR opis 1000
Green LED lights up when the power supply is established
Orange LED lights up when data connection is disconnected
Red LED lights up if an error inside the transceiver occurs
*only available at P-Ex OTR opis MC
technik@primation.de
+49 (0)89 46 26 0 - 0
P-Ex OTR opis MC