Concept2 BikeERG Product Manual page 6

PM5
Compliance Information
PM5 Assembly/
PM5
Note: As shown above, this device contains small amounts of lead. This lead is only present in glass
or ceramic (other than dielectric ceramic in capacitors, e.g. piezoelectronic devices), or in a glass or
ceramic matrix compound, per EU directive 2011/65/EU (RoHS II) Annex III exemption 7(c)-I.
FCC ID: J2MPM5
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
IC: 6620A-PM5
Industry Canada (IC) Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Industrie Canada (IC) Déclaration de conformité
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Patent application U.S. serial number 11/169712 and its corresponding applications in other countries are owned by Suunto Oy (Finland)
The Concept2 PM5 is compliant with all applicable European Union CE Marking Directives, including:
• 2004/108/EC —Electromagnetic Compatibility (EMC)
• 1999/5/EC—Radio Equipment & Telecommunications Terminal Equipment (RTTE)
• 2011/65/EU—Restriction of Hazardous Substances in Electrical & Electronic Equipment (RoHS II)
•
07/19
O