Table of Contents
Advertisement
Chapter 1
Introduction and Overview
The S100 provides computers and network devices secure synchronization to UTC time
using Network Time Protocol (NTP). The S100 can use the Global Positioning System
(GPS), NIST's Automated Computer Time Service (ACTS), or another NTP server as a time
reference.
This User Guide describes the installation and operation of the S100. It is written for network
administrators familiar with network configuration and operations.
The chapters and appendices address topics including:
• Installation, configuration, and operation
• The User Interface
• How the S100 works
• FAQ and Solutions
Here are shortcuts to those sections that answer frequently-asked "how to" or "How do I...?"
questions.
How to...
Acquire time
Choose and configure your time source
Determine the default User Name and
Password
Get Technical Support
Get time from ACTS dial-up
Get time from GPS
S100 User Guide – Rev. D – June 2005
Figure 1-1: The S100
Go here for the answer
"How to Acquire Time" on page 30
"Choose Your Time Source" on
page 33
"Setting Up the IP Address" on
page 26
"Appendix D" on page 137
"Dialup Settings dialog" on page 38
"GPS" on page 35
2
3
5
1
1
Advertisement
Chapters
Table of Contents
