How To Install Ntp V4 On A Unix System; How To Configure An Ntp V4 Client To Connect To An Ntp V4 Server With The Autokey Scheme; How To Verify Ntp V4 Autokey Client Connectivity With An Ntp V4 Server; How To Install Your S100 - Symmetricom SyncServer S100 User Manual

How to install NTP v4 on a UNIX system

Requirements: A Unix system with compiler, standard tools and
1. Download NTP tarball from
2. Extract the source using tar -xvf <
3. Run the configuration and specify autokey using
crypto=autokey
4. Run make.
5. Make install.

How to configure an NTP v4 client to connect to an NTP v4 server with the autokey scheme

1. Create or modify
autokey)
2. Run
ntpd

How to verify NTP v4 autokey client connectivity with an NTP v4 server

To confirm that a secure NTP v4 session with autokey has been established with a server, do
one of the following :
1. command showpeer <
ntpdc
2. command associations and look for
ntpq
3. Run
ntpd -ddd

How to install your S100

All information about this is covered in

How to get time using dial-up

See "Dialup Settings dialog" on page 38

How to get time using GPS

"GPS" on page
See
114
www.ntp.org
/etc/ntp.conf
and verify proper operation.
server ip
and watch output for crypto statements and packet sizes
35.
>
ntp tarball
./configure --with-
and add a server line using vi (server <
> and look for the auth flag
auth category (ok)
"Installing Your S100" on page
for details about this.
SyncServer S100
installed.
openssl
ipaddress
19.
S100 User Guide – Rev. D – June 2005
>