Rs-232 Host Parameters - Symbol DS6708 Product Reference Manual

7 - 4 DS6708 Digital Scanner Product Reference Guide

RS-232 Host Parameters

Various RS-232 hosts are set up with their own parameter default settings
Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron sets the defaults
listed below.
Terminal Specific RS-232
Table 7-2
Parameter
Transmit Code ID Yes
Data Transmission Data/Suffix
Format
Suffix CR (1013)
Baud Rate 9600
Parity Even
Hardware RTS/CTS
Handshaking Option 3
Software None
Handshaking
Serial Response 9.9 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State High
Prefix None
* In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the digital scanner connected to the proper host, it may appear unable to scan.
If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the digital scanner.
Wincor-Nixdorf
ICL Fujitsu
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
(Table
Wincor-Nixdorf
Mode
Mode A
B/OPOS/JPOS
Yes
Data/Suffix
CR (1013)
9600
Odd
RTS/CTS
Option 3
None
9.9 Sec.
One
8-Bit
Disable
Low = No data
to send
None
7-2). Selecting standard, ICL,
Olivetti Omron
Yes Yes
Prefix/Data/ Data/Suffix
Suffix
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None