Introduction; Chapter 7: Rs-232 Interface Introduction - Symbol DS6708 Product Reference Manual

Chapter 7
Chapter 7
RS-232 Interface

Introduction

This chapter describes how to set up the digital scanner with an RS-232 host. The RS-232 interface is used to
connect the digital scanner to point-of-sale devices, host computers, or other devices with an available RS-232
port (e.g., com port).
If the host is not listed in
parameters to match the host.
he digital scanner uses TTL RS-232 signal levels, which interface with most system
T
NOTE
architectures. For system architectures requiring RS-232C signal levels, Symbol offers different
cables providing TTL-to-RS-232C conversion. Contact the Symbol Support Center for more
information.
Throughout the programming bar code menus, default values are indicated with asterisks (
Most computer monitors allow scanning the bar codes directly on the screen. When
NOTE
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.
Table 7-2, refer to the documentation for the host device to set communication
*
*
Baud Rate 57,600
Indicates Default
RS-232 Interface
*
).
Feature/Option