2 - 8
MC70 User Guide
LED Indicators
The MC70 has three LED indicators. The Scan/Decode LED indicates status for scanning. The Charge Status
LED indicates status for main battery charging. The Radio Power Status LED indicates radio status.
describes the LED indications.
Scan/Decode
LED
LED Indicators
Figure 2-10
LED Indications
Table 2-3
LED State
Scan/Decode LED
Solid Green
Solid Red
Off
Charge Status LED
Slow Blinking Amber
Solid Amber
Fast Blinking Amber
Off
Radio Power Status LED*
Slow Blinking Green
Off
*The Radio Power Status LED is disabled by default. A registry setting change
is required to make this LED functional. Refer to the MC70 Integrator Guide.
For information about scanning/decoding, see Data Capture on page 2-20. For information
NOTE
about radio status and settings, see Chapter 3, Using Bluetooth, Chapter 4, Using the
MC7004/MC7094 Phone, or refer to the MC70 Integrator Guide.
Charge
Radio Power
Status LED
Status LED
Successful decode/capture.
Laser enabled, scanning/imaging in process.
Not enabled.
Main battery in EDA is charging.
Main battery in EDA is fully charged.
Charging error.
Not charging.
Any one of the radios is on.
No radio is on.
Indication
Table 2-3