Single Slot Usb/Serial Cradle - Symbol MC70 User Manual

To insert the MMC/SD card:
Power off the EDA.
1.
Remove the card cover on the side of the EDA by loosening the screws and lifting the cover out of the slot.
2.
Card Cover Removal
Figure 5-2
Insert the card with the card contacts facing down and the cut corner on the right, until you feel a click.
3.
Replace the housing cover and secure with the screws.
4.
To remove an MMC/SD card:
Power off the EDA.
1.
Remove the card cover at the top of the EDA by loosening the screws and lifting the cover out of the slot.
2.
Using the stylus, press and release the card to eject it.
3.
Remove the card from the card slot.
4.
Replace the card cover.
5.

Single Slot USB/Serial Cradle

This section describes how to use a Single Slot USB/Serial cradle with the EDA. For USB communication
setup procedures refer to the MC70 Integrator Guide.
The Single Slot USB/Serial Cradle:
• Provides 5.4 VDC power for operating the EDA.
• Synchronizes information between the EDA and a host computer. Refer to the MC70 Integrator Guide for
information on setting up a partnership between the EDA and a host computer.
Charges the EDA's battery.
•
Charges a spare battery.
•
Accessories 5 - 3