English
22
4
Shake off excess water and allow to air dry
thoroughly.
5
Place bodygroom foil back on the attachment.
Cleaning the Beard Styler Attachment
1
Remove the beard styler comb.
2
Rinse the beard styler attachment and comb
under hot water.
3
Shake off excess water and allow to air dry
thoroughly.
Tip: Lubricate the trimmer teeth with one drop
of mineral oil every 6 months.
This shaver has no other user-serviceable parts.
For assistance call 1-800-243-3050.
rEplacing thE shaving unit razor hEads
- Replace the Shaving Unit razor heads every 12
months for optimal results.
- Replace with SH30 Philips Norelco razor heads
only
1
Follow steps 1-4 under 'Extra-thorough
Cleaning Method' section.
2
Remove the shaving heads and place new ones
in the shaving head holder making sure the two
wings of the shaving heads fit exactly into the
recesses.
3
Reattach the retaining ring (1) by turning it
1
the opposite direction of the arrows on the
2
retaining ring (2).
Make sure the four wings of the retaining ring
are located exactly under the recesses of the
shaving head holder.
4
Reattach the shaving unit to the shaving
attachment. If it does not close smoothly, check
that the shaving heads and retaining rings are
positioned properly.
rEplacing thE Bodygroom foil
- Replace the Bodygroom foil every 12 months for
optimal results.
- Replace with BG2000 Philips Norelco Bodygroom
Replacement foil.
1
Pull the bodygroom foil off the attachment.
2
Place the new foil on the attachment and snap
into place.
The foil is a precision part. Handle with care.
English
23