Set-Up, Stand-By, Power-Down, Buzzer - 4titude 4S2 User Manual

4.2

Set-up, Stand-by, Power-down, Buzzer

To enter into set-up mode for stand-by, power-down and audible warning, press
the M key for 10 seconds, then release.
The display shows the symbol "L" (flashing) and the last set stand by time
(displayed as minutes).
The stand-by time is the time after which
automatically reduced to 60°C when the unit is left idle.
The stand-by time can be decreased or increased with the
"no" stand-by or between 1 minute and 99 minutes with steps of 1minute.
By pressing the M key again the new stand by time is stored and the power-
down time can be set next.
The display shows the symbol "P" (flashing) and the last set power-down time
displayed as hours).
The power-down time is the time after which the heater is switched off
automatically when the unit is left idle.
The power down-time can be decreased or increased with the
between 1 hour and 24 hours with steps of 1 hour.
By pressing the M key again the new power down time value is stored and the
audible warning (buzzer) can be set next.
The display shows the symbol "S" (flashing) and the last set buzzer function.
The buzzer function can be enabled ("on") or disabled ("no") with the
keys.
By pressing the M key again the buzzer function is stored and the unit returns
into "run mode" (see page 12) and the actual temperature of the heating
element is shown in the display.
the heater temperature is
keys
keys
11