Safety Precautions; Counter Operation - PRO Intellect Technology PRO 85 Series User Manual

5 Safety precaution and maintenance rules
• Read this manual before operation
• The manual should be available to operator
• The device should be installed on an even horizontal surface, away from water and danger-
ous objects
• Don't place the device in an area where it can be affected by direct sunlight, directional arti-
ficial light, strong vibration, or dust
• Do not operate the device with wet hands
• Do not expose to water (or other liquid). Avoid foreign objects
• Avoid dropping the device
• During operation:
When finished be sure there are no banknotes in the hopper or transport system
• Clean the device regularly and service the device as needed at a licensed service center to
comply with the specified parameters.
• Do not disassemble, repair or attempt to update the counter on your own. This can result in
damage to the device or injury to the operator. Contact a licensed service center in case of
failure
• Do not turn on the counter if the power cord is damaged
• If the device was exposed to cold for an extensive period of time, it is necessary to keep it
at the room temperature for no less than 4 hours
Remember! The producer is in no way responsible for damage to the device or injury to the
operator in the event of incorrect operation /care of the device.
6

Counter operation

Preparation
• Connect the power cord to the device
• Turn power switch ON
• Counter starts
• "0" is shown on the main display
• If an error message occurs, see Table 8
6.1. Counterfeit detection
6.1.1. The device has a CDF filter to adjust the internal settings to one of the supported
currencies. Using "CUR" button, it is important to set the device to the appropriate currency:
Rubles, USD, EURO. Indicator (Fig. 2-13) corresponds to the selected currency.
Optical density detection works to ensure the authenticity of the material used in the
banknotes and to prevent double banknote from being counted as one. It should be noted that
a stack of banknotes can contain both new and worn bills, which have different densities. In
the event that the optical density sensitivity is set to a high level, worn banknotes will result in
an error. Optical density detection is switched on by default for all counters. When none of the
currency indicators are on, this feature is OFF.
23