NEFF S Series User Manual page 51

Errors
Detergent residue in the ap-
pliance
Water marks on plastic
parts.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Cause
Tabs are used in the quick
or short programme. Dissolv-
ing time of the tab is not at-
tained.
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
White coating is deposited in
the appliance interior.
Special salt dispenser is not
screwed tight.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°°E
(8,9 mmol/l).
Troubleshooting en
Troubleshooting
Select a more intensive Programme
▶
or use Powder detergent
→ Page 34.
Change your detergent → Page 34.
▶
Select a more intensive pro-
▶
gramme.
Position tableware at an angle.
▶
→ "Arranging tableware", Page 37
Use rinse aid.
▶
→ "Rinse aid", Page 32
Set the water softening system
▶
higher.
→ "Setting water softening system",
Page 30
Change your detergent → Page 34.
▶
Clean the appliance mechanically.
▶
Set the water softening system cor-
1.
rectly.
→ "Setting water softening system",
Page 30
In most cases you will need to in-
crease the setting.
Change your detergent if required.
2.
Screw the special salt dispenser
▶
tight.
Change your detergent → Page 34.
▶
Clean the appliance mechanically.
▶
Set the Water softening system
▶
→ Page 30 to the water hardness
or add special salt.
51