Advertisement
Available languages
Available languages
Attach the two-part tubing clamp around the installed
tubing, hang into the proper position and clip into place.
Place the ready to use filter into the lower cabinet and
observe the prescribed installation height: The distance
between the water surface and the bottom of the filter
must be within 100 - 120 cm (3'3" - 3'11"). This installation
height is absolutely vital to guarantee the correct rhyth-
mic functioning of the wet/dry filter.
100 - 120 cm
Fix the intake strainer onto
the intake pipe and attach
the pipe onto the interior
glass of the tank with 2 clips
and suction cups.
Place the foam prefilter
over the intake strainer.
Attention: The foam prefilter is only to be used during the
running-in period, approx. 6 - 8 weeks. Afterwards the bac-
teria strains in the filter media take over the biological and
mechanical filtration. The foam prefilter should then be
removed.
Note:
When using with an EHEIM
professionel hood, the intake
pipe is simply clipped into
place and you don't need the
suction cups.
Connect the security outlet pipe and spray bar with a short
piece of tubing and install in the aquarium with the help of the
clip and suction cup. Close the open side of the spray bar with
the enclosed end cap.
Now direct all three tubes, starting from the filter, through
the back wall of the cabinet. First connect the installed
breathing tube (9/12 mm), without kinks and slack. Shorten
the breathing tube to the required length, connect to the
breather pipe and attach to the aquarium wall with the
clip and suction cup. Avoid placing the pipe opening
too close to the water's surface.
18
Advertisement
