Honda CB500FA 2018 Owner's Manual page 99

20180925141151_32MKPA000_eng_BOOK Page 99 Tuesday, September 25 2018 14:19:26 JST
Drive Chain Adjusting the Drive Chain Slack
u
Turn both adjusting bolts an equal
5.
number of turns until the correct drive
chain slack is obtained. Turn the adjusting
bolts counterclockwise to tighten the
chain. Turn the adjusting bolts clockwise
and push the rear wheel toward the front
to provide more slack.
Adjust the slack at a point midway
between the drive sprocket and the
driven sprocket.
Check the drive chain slack.
Check rear axle alignment by making sure
6.
the front end of the chain adjusting plate
aligns with the scale graduations on both
sides of the swingarm.
Both marks should correspond. If the axle
is misaligned, turn the right or left
adjusting bolt until the marks are aligned
and recheck chain slack.
96
Tighten the rear axle nut.
7.
Torque: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Hold the adjusting bolts and tighten the
8.
lock nuts.
Torque: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Recheck drive chain slack.
9.
If a torque wrench was not used for
P. 94
installation, see your dealer as soon as
2
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.