Honda CB500FA 2018 Owner's Manual page 123

20180925141151_32MKPA000_eng_BOOK Page 123 Tuesday, September 25 2018 14:19:26 JST
Tyre Puncture Removing Wheels
u
Make sure that the slot on the brake
2.
caliper bracket is positioned in the lug on
the swingarm.
Brake caliper bracket
Swingarm
120
Adjust the drive chain slack.
3.
Install and tighten the rear axle nut.
4.
Torque: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Slot
Hold the adjusting bolts and tighten the
5.
lock nuts.
Torque: 27 N·m (2.8 kgf·m, 20 lbf·ft)
After installing the wheel, apply the brake
6.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Lug
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
P. 95
2