Page 2 IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE Important Safety Information There is a gap between your gate frame and handle. This is not a defect. The gap on your gate will close once it is properly mounted. •...
Page 3 Installation • Measure width of opening. Step 1 • Refer to figures 1A – 1H to determine the correct installation. 29.75”-32.5” 33”-35” (75.5 to 82.5 cm) (83.8 to 88.9 cm) With 1-Bar Extension 37.8” – 40.6” 35.4” – 37.8” (96 to 103.1 cm) (89.9 to 96 cm) With 1-Bar and 2-Bar Extensions...
Page 4
Page 4 • To add an extension, begin by removing both the upper and lower Step 2 plugs from the side of the gate frame. You may need to use a flathead screwdriver to remove the plugs. Figure 2A. • Attach both the upper and lower adapters to the extension pole. •...
Page 5
Page 5 • Install wall cups. Step 3 • Place the gate in the opening so that the bottom of the gate frame is completely flat on the floor. Figure 3A. • Secure the gate, fasten the mounting cups to the wall by aligning them with the bolts with rubber pads.
Page 6
Page 6 • Tighten both of the bottom tension knobs by turning them clockwise at the same time. Figure 4A. • Tighten both of the upper tension knobs by turning them clockwise at the same time, so that the gap between the gate and upper right corner comes together, leave 1.5 ~ 2 mm gap as shown in figure 4B.
Page 7 Operation Opening the gate: Pull back the button on the top of the handle with your thumb, squeeze the trigger on the lower side of the handle, then lift the inner door up and open the door. Closing the gate: Your gate has an easy-close feature. You can leave the gate in the open position and when ready, simply push the gate door closed until it clicks.
Page 8
Never use solvents or chemicals to clean the safety gate. For instructions in Spanish or French, please visit www.northstatesind.com Distributed exclusively in the United States by North States Industries, Inc. 5455 Highway 169 N Plymouth, MN 55442 www.northstatesind.com Manufactured in China...