Plugging In Your Equipment; Getting Started - PS Audio Stellar PowerPlant 3 Owner's Reference Manual

Plugging In Your
The Stellar PowerPlant 3 has a total of six (due to varying outlet sizes, the German,
Equipment
Austrailian, and United Kingdom versions of this product will only have four) outlets for
regenerated power, two of which can be used for equipment requiring a higher output
current than the P3 can support. To activate the Filtered High Current setting on those
two outlets, flip the bypass switch on the rear panel to the up position (as pictured below).
By selecting Filtered High Current, the regenerator will be bypassed and your AC power
will be filtered and able to deliver up to 13A of current.
CAUTION: YOU MUST SHUT OFF THE UNIT'S POWER BEFORE SWITCHING BETWEEN
THE FILTERED HIGH CURRENT AND REGENERATING SETTINGS.
With the P3 powered off, plug in your desired equipment to the outlets on the back panel
of the unit.
Powering On
Once the unit is connected to power, flip the master power switch on the rear panel to the
Your P3
on position. The PS Audio Logo LED button on the upper left corner of the front panel will
flash for approximately 3 seconds while the unit initilizes. Once you hear a click and the
Logo LED button is glowing solid blue, the unit has finished initializing and is ready for use.
®

Getting Started

Stellar PowerPlant 3
8