Multiwave Function; Cleanwave Function - PS Audio Stellar PowerPlant 3 Owner's Reference Manual

MultiWave
The MultiWave function increases the charge time of the P3's output waveform by altering
Function
the peak of the sine wave. A longer charging time, occurring at the peak of the output
sine wave, lowers the connected equipment's power supply ripple, much the same way
as increasing the power supply capacitance of connected equipment.
To toggle this feature on and off, press the MW button on the remote. The MultiWave
LED on the front panel will glow blue when MultiWave is turned on. When the MultiWave
function is turned off, the P3 uses the traditional sinewave as its default waveform.
CleanWave
CleanWave injects a series of higher frequencies that ride on the main sine wave to help
Function
degauss connected magnets. To enable this function, press the Clean button on the
remote. To ensure that CleanWave is effective, make sure all connected equipment is
on and functioning. CleanWave can be used between CDs, movies, and vinyl. It is not
recommended to activate CleanWave while you are listening, as it may not sound correct
until the CleanWave cycle has finished. The cycle will last for 5 seconds, during which time
the CleanWave LED on the front panel will glow blue. When the cycle has finished, the
LED will turn off.
11
®
Operation Guide
Stellar PowerPlant 3