Lincoln Electric Power MIG 360MP Operator's Manual page 16

®
POWER MIG 360MP
WELDING PROCESSES MENU
Manual MIG
See section on installing wire and setting up MIG gun.
Use this process to bypass Ready.Set.Weld
manually input MIG welding wire feed speed and voltage.
MIG (GMAW) / Flux Core (FCAW-S) / Gas
Shielded Flux Core (FCAW-G)
TM
Follow Ready.Set.Weld prompts and insert parameters per your
application.
Once on the home screen, use the left selector knob to adjust the
wire feed speed.
For CV processes, use the right selector knob to adjust voltage.
For pulse processes, use the right selector knob to adjust trim.
Trim adjusts the arc length and ranges from 0.50 to 1.50 with a
nominal value of 1.00. Trim values greater than 1.00 increase the
arc length, while values less than 1.00 decrease the length.
Access Pulse and Pulse-on-Pulse
See Special Welding Processes section for further details.
Spool Gun/Push-Pull
These modes are for use with an optional spool or push-pull gun.
These processes may require the calibration of your gun before
use. You can choose to calibrate your gun in the Ready.Set.Weld
options of this process.
When selecting a material, 4xxx indicates aluminum that is
primarily alloyed with silicon. 5xxx indicates aluminum that is
primarily alloyed with magnesium.
Once on the home screen, adjust the WFS via the remote pot on
the gun.
For CV processes, use the right selector knob to adjust voltage.
For pulse processes, use the right selector knob to adjust trim.
Trim adjusts the arc length and ranges from 0.50 to 1.50 with a
nominal value of 1.00. Trim values greater than 1.00 increase the
arc length, while values less than 1.00 decrease the length.
TIG (GTAW)
Follow Ready.Set.Weld™ prompts and insert parameters per your
application.
Use the right selector knob to adjust the weld current.
Note: The green section indicates the ideal range for the input
welding parameters.
If no foot pedal is connected, you must turn on the weld output
before welding. While on the Home Screen, turn on the weld
output by turning the left selector knob clockwise. Turn off the
welding output by turning the left selector knob counter clockwise.
If a foot pedal is connected, pressing the foot pedal turns on the
welding output, and releasing the pedal turns off the output.
The welding output must be turned off before accessing the Weld
Settings.
Access TIG Pulse via the Weld Settings menu. See Special Welding
Processes section for further details.
™
options and
®
via the Weld Settings menu.
Stick (SMAW)
Select between Soft or Crisp arc
Soft: Has a less penetrating arc characteristic. For low hydrogen
types of electrodes (E7018, E8018, E9018, etc) a softer arc is
usually desirable.
Crisp: Has a higher energy arc characterized by more penetration.
For cellulosic types of electrodes (E6010, E7010, E6011,etc) a
higher energy arc is required to maintain arc stability. This is
usually indicated when the electrode sticks to the work-piece or
when the arc pops-out during manipulative technique.
You must turn on the weld output before welding. While on the
Home Screen, turn on the weld output by turning the left selector
knob clockwise. Turn off the welding output by turning the left
selector knob counter clockwise.
The welding output must be turned off before accessing the Weld
Settings.
TM
B-5
INSTALLATION