Other Overviews - Sylvania HDRV200F Quick Manual

Other Overviews

Installing batteries in the remote control
Install two AA-size batteries (supplied), matching their
polarity to those indicated inside the battery compartment
of the remote control.
1 2
Battery use and care
Incorrect use of batteries can result in hazards such as leak-
age and bursting. Please follow the instruction below:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries may
have different voltages.
• Make sure that the plus and minus ends of each battery
match the indications in the battery compartment.
• Remove batteries from equipment that is not going to
be used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or public rules for environ-
mental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disas-
semble batteries.
Using a remote control
Keep in mind the following when using the remote control:
• Make sure that there is no obstacle between the remote
control and the remote sensor of the unit.
• Remote operation may become unreliable if strong sun-
light or fluorescent light shines on the remote sensor of
the unit.
• Remote control for different devices can interfere with
each other. Avoid using remote controls for other
equipment located close to the unit.
• Replace the batteries when you notice a fall-off of the
operating range of the remote control.
• The maximum operable ranges (approximate) from the
unit are as follows.
- Straight line:
- Either side of center: 16 feet (5 m) within 30°
- Above:
- Below:
POWER STOP/EJECT REW F.FWD PLAY REC/OTR
23 feet (7 m)
16 feet (5 m)
(30 )
16
Before You Start
Functional Overview (Cont'd)
3
23 feet (7 m)
16 feet (5 m) within 15°
10 feet (3 m) within 30°
16 feet (5 m)
(15 )
OPEN / CLOSE
CHANNEL DUBBING VCR HDD DVD STOP PLAY HDD REC/OTR DVD
VCR DVD
RESET
HDD DVD
16 feet (5 m)
(30 )
10 feet (3 m)
(30 )
Switching HDD / DVD / VCR modes
Because this product is a combination of a HDD, DVD, and
VCR recorder, you must select first which component you
wish to operate.
HDD mode
Press HDD on the remote control.
(Verify that the HDD indicator is lit.)
DVD mode
Press DVD on the remote control.
(Verify that the DVD indicator is lit.)
VCR mode
Press VCR on the remote control.
(Verify that the VCR indicator is lit.)
Device Select Buttons / Indicators
POWER STOP/EJECT REW F.FWD PLAY REC/OTR
VCR HDD DVD
Note
• Pressing the device select button on the front panel
DOES NOT switch the device mode of the remote
control. You MUST select the correct device mode
on the remote control.
• If you press REC / OTR of each device, recording
starts in its device mode.
• When the buttons listed below are pressed, the unit
switches to the HDD / DVD mode.
- TIMER PROG.
- SETUP
- DUBBING MENU
• When the button listed below is pressed, the unit
switches to the HDD mode.
- PROGRAM RECORDINGS
S-VIDEO VIDEO L AUDIO R
OPEN / CLOSE
CHANNEL DUBBING VCR HDD DVD STOP PLAY HDD REC/OTR DVD
VCR DVD
RESET S-VIDEO VIDEO L AUDIO R
HDD DVD
DVD Button
HDD Button
VCR Button
DVD Button / Indicator
HDD Button / Indicator
VCR Button / Indicator
TIMER INPUT OPEN/CLOSE
POWER PROG. SELECT EJECT
.@/: ABC DEF
1 2 3
CHANNEL
GHI JKL MNO
4 5 6
PQRS TUV WXYZ
7 8 9
SPACE
0
PROGRAM
RECORDINGS SETUP AUDIO CLEAR
MENU/LIST TOP MENU
ENTER
DISPLAY RETURN
VARIABLE VARIABLE
SKIP REPLAY SKIP
REV PLAY FWD
SLOW STOP PAUSE
VCR HDD DVD
REC MONITOR
REC MODE REC/OTR REC/OTR REC/OTR
DUBBING MENU SEARCH MODE