Table of Contents
Advertisement
Vinotemp International ● 17621 S. Susana Road, Rancho Dominguez, CA 90221
Shelves
•
This appliance is equipped with a pull-out roller assembly (except for the
bottom shelf) and you can move the shelves in and out smoothly.
•
To prevent damaging the door gasket, make sure to have the door opened all
the way when pulling the shelves out of the rail compartment. For easy
access to the bottles, you must pull the shelves approximately 1/3 out of the
rail compartment.
•
To remove the shelves from the rail, pull each shelf approximately 1/3 of the
way out. Use a long flathead screwdriver to press down on the left plastic
notch (as shown in Figure A) and at the same time lift the right plastic notch
as shown in Figure B. Then proceed to slowly pull out the shelf.
Figure A
Display Shelf
•
This wine cooler also includes an optional display shelf. To utilize the
display function, pull the shelf approximately 1/3 of the way out of the rail
compartment as shown in Figure C.
•
Lift the shelf straight up and out of the rail compartment as shown in
Figure D. Remove the shelf from the cooler.
•
To replace the display shelf, repeat these steps in reverse.
Note
•
If the unit is unplugged, a power outage occurs, or the unit is turned off, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the wine cooler will not start.
•
When you use the wine cooler for the first time or restart the wine cooler
after having been shut off for a long time, there could be a few degrees
variance between the temperature you select and the one indicated on the
temperature display. This is normal and it is due to the length of the
activation time. Once the wine cooler runs for a few hours, everything will be
back to normal.
Figure B
11
Advertisement
Table of Contents
