Table of Contents
Advertisement
1. Installation
1.6 Electric connection
The electric system, as prescribed and specified by the Standard in force, must be
equipped with an efficient ground. It is possible to guarantee the electric safety of the
appliance only in the presence of Standard electric system.
For direct connection to the mains it is necessary to interpose a device between the
equipment and the same mains, dimensioned depending on the load, that ensures its
disconnection and which contacts have an opening distance enabling the full discon-
nection in the conditions of over-voltage category III, in compliance with the instal-
lation regulations; this device also must be located in a place and in a manner to be
easily accessible at any moment by the operator.
Bring the main switch, to which the power supply cable plug will be collected, in position
0 (zero).
Have professionally qualified staff check that the plug cables section is adequate to the
power absorbed by the appliance.
Loosen the screws fixing the left side of the oven and extract it.
ELECTRIC OVENS
L1 L2 L3 N
N
tab 1
nominal voltage value of ±10%.
The equipment must be included in an equipotential system which efficiency must be
checked according to that reported in the Standard in force.
For the connection there is a clamp, located on the frame and marked with the symbol
to which a cable with minimum section of 10 mm² must be connected.
For gas ovens, complete gas connection to the appliance before assembling
the oven side again;
for electric ovens assemble the oven side.
8
GAS OVENS
L
N
X
Between phases
and
there must be
a potential difference
of 230 V
Connect the cable to the terminal board
following the indications on "tab 1".
Lock the cable with the cable gland.
The power supply voltage with machine
funcioning,must not be different from the
Advertisement
Table of Contents
