Magnifico MR3 Use And Maintenance Manual page 6

1. Installation
Connect the oven to the gas supply using a special R 1/2"
hose with an internal section of at least 16 mm.
Connection to gas supply must be carried out using rigid or
flexible metal pipes. Use taps or gates with an internal diame-
ter that is greater than that of the hose.
After connecting the appliance to the gas supply make sure
that there are no leaks from joints or connections. You can
test for leaks by using soapy water or foaming agent for leak
detection.
Gas ovens should be inspected in compliance with spe-
cific regulations once a year by an authorised techni-
cian who will analyse combusted gases and check no-
minal heat rating.
The appliance can work correctly only when gas pres-
sure keeps within specific values for each gas type (see
table).
If the pressure falls outside these values, it will not be possible
to achieve optimum functioning of the appliance and for it to
be installed permanently. Should this happen, call a technician
to check your gas mains (ducts, gates and eventually pressure
reducers) then, if necessary, contact your gas provider.
6