Switching On Oven And Testing - Magnifico MR3 Use And Maintenance Manual

1. Installation

1.8 Switching on oven and testing

Before switching on the oven, carefully check that all systems and installation of the appliance are in compliance
with current laws and with the technical and safety guidelines in this manual.
Check the following:
•
The oven must be installed in a room where the temperature is over +4° C.
•
The oven chamber must be empty.
•
All packaging has been completely removed, including the protective film applied to the walls of the oven.
•
Vents and ventilation openings must be open and unobstructed.
•
Any parts that have been removed for installation purposes must be replaced.
•
The main switch must be switched on and the water and gas taps must be open.
•
Acoustic signal may occur when the oven receives power supply.
Testing
:
The oven should be tested by carrying out a trial cooking session to check that the appliance is working properly and
that there are no problems or malfunctioning. Set the temperature controller at 150° C and the timer to 10 minutes.
Check every item in the list below:
•
The light in the oven chamber switches on.
•
The oven switches off if the door is opened and starts up again after the door has been closed.
•
The temperature controller regulating the oven temperature is activated, causing the heating elements to
switch off temporarily, when the set temperature has been reached; temperature controller activation is indi-
cated by the "HEATING" led display located on the oven control panel switching off.
•
Every 2 minutes the fan motor automatically reverses direction of rotation followed by a 20-second rest.
•
During the 20-second motor rest the "HEATING" led display located on the oven control panel will temporarily
go off showing that the oven chamber heating elements have been temporarily switched off.
•
For 7-trays and 10-tray ovens: the two fans in the oven chamber rotate in the same direction.
•
At the end of the cooking session the oven alarm sounds for about 15 seconds.
•
If the oven is equipped with a humidity controller, after using knob to activate it, check that water is being
discharged to the fan from the humidity inlet duct in the oven chamber.
10