Printing Of Measurement Values; Further Measurements; How To Switch Off The Alcoquant® 6020 - Envitec AlcoQuant 6020 Operating Instructions Manual

After pressing "Print"-Button a measurement report will be printed by an attached Printer
(optional accessory).
If the measured value is above of the measurement range (0-5,5
following message:
Additional it is signalised acoustically by a short dual signal and optically by the red LED.
6.2.3 6.2.3 6.2.3 6.2.3 Print

Printing of measurement values

Print Print ing of measurement values ing of measurement values ing of measurement values
Press the "Print"-Button while the measured value is shown (Section 6.2.2 and 8.1) a
measurement report will be printed by an attached Printer (optional accessory).
ATTENTION:
After the „Print"-Button has been pressed the device not responds to any keypress for approx. 5sec. In this time the device
sends the data to the connector.
6.2.4 6.2.4 6.2.4 6.2.4

Further measurements

Further measurements Further measurements Further measurements
After briefly pressing the "OK" key
the sensor system is rinsed. Thereafter the procedure is the same as the sequence in Section
6.2.2.
6.3 6.3 6.3 6.3 How to switch off the AlcoQuant® 6020 How to switch off the AlcoQuant® 6020 How to switch off the AlcoQuant® 6020 How to switch off the AlcoQuant® 6020
The "ON/OFF" key
6020. The device then switches off.
ATTENTION:
If no measuring procedure is carried out within 2.5 minutes of the device becoming ready to operate, the AlcoQuant®
6020 switches off automatically.
ATTENTION:
The background lighting of the display switches off automatically after 15 sec. and is reactivated by pressing any key.
When the background lighting is switched off the first press of a key is used to switch the lighting on and does not affect
the menu navigation.
12
the device is prepared for the next measurement and
must be pressed for approximately 3 sec. to switch off the AlcoQuant®
AlcoQuant® 6020 – Breathalyser – Operating Instructions
the display shows the
‰)