Gamber Johnson 7160-0392 Installation Instructions

INSTALLATION INSTRUCTIONS

Product
7160-0392
HP/Canon Printer Mount
The 7160-0392 HP/Canon Printer Mount is designed to hold HP 100 & H470 printers
and Canon i100 & i90 printers.
Older model HP and Canon printers, as well as other similar sized printers, may also
fit in the printer mount.
The 7160-0392 HP/Canon Printer Mount is typically used with a Gamber-Johnson
DS-74-L mount as described below.
The Printer Mount can also be installed in other arrangements, but the installer
may need to supply longer mounting hardware and spacers.
The Gamber-Johnson 7160-0351 isolator mount can be used with the printer mount
for extra protection against shock and vibration.
A 7/16" Socket & Rachet or Wrench and a Phillips Screwdriver are needed for installation.
Side Brackets
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal in jury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
©Copyright 2011 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Revision
Rev. A
Back Brackets
1. The 7160-0392 Printer Mount
is shipped in it's most compact
form.
Loosen nuts securing the side and
back brackets to open the printer
mount.
Form
INST-553
Printing Spec. PS-001
Side Brackets
1 / 2