Toro Reelmaster 5010-H Series Installation Instructions Manual page 3

Mounting the Roller-Brush
Housing
1. Ensure that the O-ring is installed on the
roller-brush housing
1. Roller-brush housing
2. For Model 03408 only: Mount the roller-brush
housing to the reel-bearing housing with 2
hex-socket bolts (3/8 x 1 inch); refer to
Note:
Position the roller-brush housing so that
the threaded hole is toward the front of the
cutting unit.
Note:
Ensure that the O-ring is properly
positioned in the roller-brush housing.
1. Roller-brush housing
2. Threaded hole
3. For Model 03406 kit with RM5010 tractors with
the following:
•
Hydraulic 5-inch reel motors, install 2
bolts (5/16-18 x 1/2 inches) on top of the
roller-brush housing
•
Electric 5-inch reel motors, install the
end-weight kit on top of the roller-brush
(Figure 3).
Figure 3
2. O-ring
Figure
Figure 4
3. Hex-socket bolt
(Figure 5).
housing with 2 bolts (5/16-18 x 1 1/2 inches);
refer to
g020371
1. End-weight kit (Model
03413, electric reel motor)
2. Bolts (5/16-18 x 1/2 inch),
hydraulic reel motor
4.
Installing the Roller Brush
Assembly
1. Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing (Figure
g221538
1. Grease fitting
2. Install the 90-degree grease fitting so that it
faces backward
3
Figure 5.
Figure 5
3. Roller-brush housing
7).
Figure 6
(Figure 6).
g028040
g031872