Toro Reelmaster 5010-H Series Installation Instructions Manual page 2

Determining the Roller
Brush Orientation
All cutting units are shipped with the counterweight
mounted to the left end of the cutting unit. Refer to
Figure 1 to determine the position of the roller brush
and reel motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note:
These instructions and illustrations show the
installation of the kit on cutting units with the end
weights mounted on the left end of the cutting unit.
Figure 1
5. Cutting unit 5
6. Reel motor
7. Right roller-brush drive
assembly
8. Left roller-brush drive
assembly
Installing the Roller Brush
Installing the Driveshaft
1. Park the machine on a level surface and set the
parking brake.
2. Ensure that the cutting units are disengaged.
3. Shut the engine off and remove the key.
4. Remove all the cutting units from the machine.
Important:
desired height of cut and attitude. Make
adjustments per the Operator's Manual, if
required, before installing the kit.
5. Restrain the reel for removal; refer to
g027187
the Reel for Removing Threaded Inserts (page
10).
6. Remove the cutting-unit threaded insert for the
rear-roller-brush drive
(Figure 2).
1. Threaded insert
(left-handed insert shown)
2. The left-hand insert has a
groove on the face of the
insert here.
Note:
Left-handed inserts are on cutting units
1, 3, and 5
7. Restrain the reel for installation; refer to
Restraining the Reel for Installing Threaded
Inserts (page
8. Apply thread-locking compound to the driveshaft
threads (Figure
torquing it to 115 to 128 N·m (85 to 95 ft-lb).
2
Check the cutting unit for the
(Figure 1) and discard it
Figure 2
3. Driveshaft
4. Apply thread-locking
compound here.
(Figure 1).
11).
2) and install the driveshaft,
Restraining
g032009