Network Setting - Canon NA10 User Manual

Web Menu Settings
This section describes the setting items on each of the pages of the
web menu.
Scanner Name Setting
If you click [Scanner Name Setting] on the left menu, the page below
is displayed.
Item Description
Displays the device name of the connected
Scanner Name
scanner.

Network Setting

If you click [Network Setting] on the left menu, the page below is
displayed.
Item Description
Enable ([ON]) / disable ([OFF]) the
DHCP protocol.
DHCP To assign an IP address using
DHCP, the DHCP server must be
running in your subnetwork.
Set the IP address of the device.
If DHCP is enabled, the IP address
obtained from it will be applied.
IP Address The value must be four decimal
numbers separated by dots and
expressed in the [xxx.xxx.xxx.xxx]
format.
Set the subnet mask of the device.
If DHCP is enabled, the subnet
mask obtained from it will be
Subnet applied.
Mask The value must be four decimal
numbers separated by dots and
expressed in the [xxx.xxx.xxx.xxx]
format.
Default Value
ON
192.168.0.10
255.255.255.0
23