Table of Contents
Advertisement
Wireless converter intermediate plug
Disconnect the connection to the Radio Bus actuator (C)
Disconnection should take place before an actuator is replaced, so that occupied gateway
channels can be made free again, or before resetting to the factory setting.
o
Switch the Radio Bus actuator to be disconnected to programming mode (see Radio Bus
actuator instructions).
The LED of the Radio Bus actuator flashes slowly.
o
Press the transmitter channel button connected to the Radio Bus actuator for longer than
one second or the scene button for longer than three seconds.
The connection to the Radio Bus actuator is disconnected. The LED of the actuator flashes
quickly.
o
Exit the programming mode of the Radio Bus actuators (see Radio Bus actuator
instructions).
Disconnect the connection between the eNet transmitter and the gateway (D)
o
Press the Prog button (3) of the gateway for longer than 4 seconds.
The status LED flashes after 4 seconds. The gateway is in programming mode for
approx. 1 minute.
o
Switch the eNet transmitter to programming mode as well (see eNet transmitter
instructions).
o
Briefly press the connected button of the eNet transmitter.
The connection is disconnected. The LED flashes for a few seconds.
32582112
10865123
Figure 4: Disconnecting
11.04.2017
4/8
Advertisement
Table of Contents
