Setup Wizard; Info; Backlight - Hama DIT2100MSBT Operating Instructions Manual

• Set Auto-check setting to YES to have the radio
automatically check for new software updates at regular
intervals. (Recommendation)
• Choose Check now to manually start a check for
software updates.
Warning
• Make sure that the radio has a stable power supply
before you start a software update.
• Power supply failure during a software update can
cause irreparable damage to the radio.

17.7 Setup wizard

You can restart the setup wizard
any time by proceeding as follows:

17.8 Info

• To have the radio display current information about
its hardware and software (version numbers, device
designation, radio ID, etc.), proceed as follows:
• If you have already registered your radio on
the online portal of Frontier Silicon
(http://www.wifiradio-frontier.com), then
you can find out the radio ID there, as well.
(5.4.1. Setup wizard) at
[menu]
System settings

Setup wizard
[menu]
System settings

Info

17.9 Backlight

Brightness sensor activated
• Move the sliding switch (27) to the ON position.
• The brightness of the display is now automatically
adjusted according to the ambient brightness.
Brightness sensor deactivated
• Move the sliding switch (27) to the OFF position.
The backlight can be configured for each operating
mode (Operation Mode, Standby Mode, Slumber Mode)
separately.
• Proceed as follows:
• For the operation modes Operation Mode and
Slumber mode, select between various brightness
levels.
• For Standby Mode, you may also choose a brightness
level for the backlight when the radio is in standby
(Standby Level). Alternatively, you can set the backlight
to turn off completely in standby (Standby Level 
Off).
• Choose a time interval for Timeout. When the radio is in
standby, press [navigation] to illuminate the display at
the brightness level set for that operating mode for the
selected interval of time.
• Alternatively, you can disable this feature (Timeout 
Off).
Alternatively, press [
adjust the backlight setting for the current operating mode.
36
[menu]
System settings

Backlight
] on the remote control to directly