Table of Contents
Advertisement
The HKC-7080 is the modification unit for the HDC-700. By installing the HKC-7080 in the HDC-700, it
can be obtained for the HD signal having 1920 x 1080 effective picture elements. To install proceed as
follows.
1-1. Configuration of HKC-7080
Description
CCD unit
ROM M27V201-HDCA750-V4.03 and up
ROM M27V201-HDC750-V4.03 and up
Modification board (with jumper wires)
Jumper wires
Installation and maintenance manual
1-2. Installation Procedures
This section explains briefly on installation and modification procedures. For more details, refer to the
corresponding section.
1. Replacing CCD unit (Refer to Section 1-3.)
2. Modifying board (Refer to Sections 1-4-1 to 1-4-4.)
3. Replacing ROM (Refer to Section 1-4-5.)
4. Setting switch (Refer to Section 1-4-6.)
5. Electrical alignment (Refer to Section 2.)
1-3. Replacing CCD Unit
1-3-1. Description on CCD Block Number
Every CCD unit has its own ID number called CCD block number. It shows the CCD block type and
serial number for the CCD block.
The CCD block number label is put in the CCD unit.
Ex.) AGAxxxxx
Serial number for CCD block
CCD block type
HKC-7080
Section 1
Installation
Q'ty
Remarks
1
1
For IC24/SG-226 board
1
For IC26/IF-569 board
1
Used when modifying the VA-158 board
2
Used when modifying the IF-569 and SG-226 boards
1
1-1 (E)
Advertisement
Table of Contents
