Table of Contents
Advertisement
This section explains adjustment items required after the
HKC-7080 is installed.
Perform the following adjustments with setup menu.
Regarding the setup menu operation, refer to Section 3.
2-1. Preparation
2-1-1. Equipment Required
Measuring equipment
. Oscilloscope (band-width: more than 300 MHz)
Tektronix 2465B or equivalent
. HDTV analog waveform monitor
Tektronix 1735HD/1730HD or equivalent
Peripheral equipment
. HD camera control unit HDCU-700A
. Master setup unit
Tools
. Extension board EX-512
Sony Part No. A-8273-247-A
. Pattern Box PTB-500
Sony Part No. J-6029-140-B
. Gray scale chart (16:9)
Sony Part No. J-6394-080-A
HKC-7080
Section 2
Electrical Alignment
MSU-700 (HKCF-700 should
has been installed.)
2-1-2. Switch Setting of IF-569 Board
1. Turn off the power, then remove the IF-569 board.
2. Set the switch S1 on the IF-569 board as shown below.
1
2
3
4
5
6
3. Restore the IF-569 board, then turn on the power. (The
data stored inside the RAM will be cleared.)
4. Restore the switch setting of S1 on the IF-569 board as
shown below.
1
2
3
4
5
6
2-1-3. Clearing the Reference File
Perform the following operation with setup menu.
MENU: File
PAGE: Reference File
ITEM: Clear File
(Press the MENU SELECT switch toward the ENTER to
clear the reference file.)
2-1-4. Presetting the Operator File
Perform the following operation with setup menu.
MENU: Operation
PAGE: Operator File
ITEM: Preset
(Press the MENU SELECT switch toward the ENTER to
preset the operator file.)
7
8
7
8
2-1 (E)
Advertisement
Table of Contents
