Table of Contents
Advertisement
3-1. Setup Menu
3-1-3. Maintenance Menu
Page
Ver.
Item
Camera Setup
H Phase
FREQ SEL
Fan Mode
Link Tally
BATT Type
Alarm VOLT
SDI/VTR Setup
Prompter
Serial Output
Optical
Cable COMP
Output Signal
CN Output
Date/Time
DD/MM/YY
HH:MM
Area SEL
Timer
Camera ID
Camera ID
f)
If "RED" is indicated, be sure to clean the optical connector or optical connector cable. If "YEW" is indicated, cleaning them is
recommended. For details on how to clean, refer to Section 2-15.
3-12 (E)
Settings
_100 to 100 ([0])
60, [59.94] Hz
[Auto1], Auto2, MIN, Off
On, [Off]
[Lithium], Others,
CCU, Anton, BP-90
10.0 to 13.0 V ([10.0])
On, [Off]
On, [Off]
On, [Off]
RGB, [YPbPr]
[Main], RET
GMT_12 to +12 (+[9])
Contents
Adjusts the H phase
Selects the field frequency
Auto1: Normal mode
Auto2: Silent mode
MIN:
Minimum turn mode
Off:
Forcibly turned off
On: The unit enters the above-mentioned MIN mode with a
tally signal input
Off: The mode determined by the above setting is valid all the
time
Select according to a battery in use
This setting enables the battery alarm voltage indication
corresponding to the battery characteristics
Sets the battery alarm voltage (Stores the voltages for every
battery)
On: Prompter signal is output at PROMPTER connector
(This setting is valid only when HDCU is connected )
Off: No prompter signal is output
On: SDI signal is output at SERIAL OUT connector
Off: No SDI signal is output (This setting is valid only when the
camera is used alone )
Displays a photo-receptive condition of the optical connector of
camera adaptor
(Corresponds to the indicator on DPR-77 board of HDCU)
____: When the camera is used alone
*
GRN:
Normal (_17 dBm
or more)
YEW: Normal (_17 to _20 dBm
RED:
Abnormal (less than _20 dBm
NG:
Out of sync with HDCU
*
0dBm = 1 mW
Turns on and off the VTR (26P) cable compensation
Selects the main signal to be output to a VTR
Sets the VTR connector
Adjusts a built-in calendar and timer
Sets the standard time in various countries
Indicates the power-on time of the unit
Sets a camera ID of up to ten alphanumerics, symbols, and
spaces
f)
*
)
*
)
HKC-7080
Advertisement
Table of Contents
