Better Homes and Gardens BH44-084-399-04 Assembly Manual page 6

B
Large Lock Washer
(4 used in this step)
6. Remove the plastic caps from the hanger bolts of the Front Legs (B). Attach 2 Front Legs (B) to the front
corner blocks of the Seat Frame (C) by inserting the pre-attached hanger bolts through the pre-drilled
holes on the corner blocks, and fit the Large Flat Washer (6), the Large Lock Washer (5) and the Hex
Nut (7) onto each hanger bolt. Tighten the Hex Nuts with the provided Open Wrench.
NOTE: DO NOT fully tighten all the nuts until the chair has been adjust and level all the legs so that
they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
7. Stand the assembled chair upright on a flat surface. Press down the Seat Board (D) to even all legs. Now,
tightly fasten all bolts and nuts with the hex-key and open wrench provided.
8. Repeat the same process to assemble the other chair.
Assembly Instructions
B
C
A
Large Flat Washer
(4 used in this step)
⑤
6
5
7
⑥
6
B
B
C
Hex Nut
(4 used in this step)
⑦