Using The Machine - Husqvarna DMS 160 A Operator's Manual

Using the machine

• Keep your hands at a safe distance from the drill spindle
and drill bit when the machine is running.
• Keep an eye open for oil or water leakage.
Drilling outdoors
Always use extension cables that are approved for outdoor
use.
Changing the drill bit
1 Pull out the plug.
2 Get:
- The new drill bit.
- The supplied open-ended spanners, size 24 mm and 32
mm.
- Water-resistant grease.
3 Remove the old drill bit using the open-ended spanners.
4 Apply water-resistant grease to the thread of the new drill
bit.
5 Attach the drill bit using the open-ended spanners.
Slip clutch (SMC)
The machine is equipped with a mechanical slip clutch
(SMC).
Tension the slip clutch as follows:
• Loosen the cover for the slip clutch.
2
1
• Carefully lock the hook nut using a flat wide screwdriver in
one of the hook nut's four notches.
• Turn the drill spindle with a 27 mm open-ended spanner
15 degrees.
Remove the screwdriver and refit the cover on the slip clutch.
14 –
English
WORKING TECHNIQUES
3
Load/power indication (LCS-Load control
system).
The machine works at its best if not overloaded, let the
maximum yellow LED on the load/power indicator (LCS- Load
Control System) be on. Max. 10 minutes max. load the
machine must then be run without a load for 2 minutes.