Working Techniques; General Working Instructions - Husqvarna DMS 160 A Operator's Manual

Hide thumbs Also See for DMS 160 A:
Table of Contents

Advertisement

Available languages

Available languages

General working instructions

WARNING! This section takes up the basic
!
safety precautions for working with the
drilling machine. This information is never a
substitute for professional skills and
experience. If you encounter a situation
where you are uncertain how to proceed you
should ask an expert. Contact your dealer,
service agent or an experienced drilling
machine user. Do not attempt any task that
you feel unsure of!
WARNING! Overexposure to vibration can
!
lead to circulatory damage or nerve damage
in people who have impaired circulation.
Contact your doctor if you experience
symptoms of overexposure to vibration.
Such symptoms include numbness, loss of
feeling, tingling, pricking, pain, loss of
strength, changes in skin colour or
condition. These symptoms normally appear
in the fingers, hands or wrists. These
symptoms may be increased in cold
temperatures.
Do not use the machine in bad weather, such as dense
fog, rain, strong wind, intense cold, etc. Working in bad
weather is tiring and can lead to dangerous conditions,
e.g. slippery surfaces.
Never start to work with the power cutter before the
working area is clear and you have a firm foothold. Look
out for any obstacles with unexpected movement. Ensure
when cutting that no material can become loose and fall,
causing operating injury.
Remain at a distance from the drill bit when the motor is
running.
Ensure that the working area is sufficiently illuminated to
create a safe working environment.
Make sure that no pipes or electrical cables are routed in
the area to be drilled.
Ensure the cord is behind you when you start to use the
machine so that the cord will not be damaged.
Never leave the machine unsupervised with the motor
running. A rotating drill bit can entail a risk of serious
injury.
Always unplug the machine during longer work breaks.
Do not overload the machine. Overloading can damage
the machine.
Keep tools sharp and clean in order to enable safer work.
Always check the rear side of the surface where the drill
bit will emerge when drilling right through. Secure and
cordon off the area and make sure that no one can be
injured or material damaged.
Always switch off the machine before you move it.

WORKING TECHNIQUES

Never work alone, always ensure there is another person
close at hand. Apart from being able to receive help to
assemble the machine, you can also get help if an
accident should occur.
Keep all parts in good working order and ensure that all
fixtures are properly tightened.
– 13
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dms 160 atDms 160 gyro

Table of Contents