Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATA 400 RE-BAR 25 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sima ATA 400 RE-BAR 25

  • Page 2: Specifications And Technical Information

    Warning: Read this user guide before use. The user guide should be kept together with the RE-BAR tier. 1. Specifications and technical information Wire Guide C Reel Stopper Front and back of the machine Main Switch Window Release Lever Adjusting Knob Label Arm A Unit Curl Guide...
  • Page 3: Safety Features

    The batteries for the TJEP RE- Las baterías de su atadora SIMA son BAR tier are Li-Ion. It may be illegal to dispose of the battery through the ordinary waste system. Your local waste authori- ties can inform you how to dispose of and recycle this type of battery correctly.
  • Page 4: Safety Instructions

    4. Safety instructions 4.1.6. Check the parts of the RE-BAR tier before inserting the battery. Caution Check that all screws are tightened prop- To avoid serious injuries to erly. Improper tightening of screws can persons or property, please read result in an accident or breakage. If parts these safety instructions carefully are missing or need to be repaired, contact and make sure you understand them.
  • Page 5 ƒ The RE-BAR tier starts itself without be- 4.2.4. Never charge the battery in a wet ing activated. or damp environment. ƒ Do not use the RE-BAR tier without cor- Charging in these conditions may cause an recting the fault. electric shock or short circuit.
  • Page 6 5. How to use 5.1. Loading the wire coil. WARNING: Set the main switch to 0 position, activate the trigger lock and remove the battery. Release lever Release stopper Wire guide C Wire guide 5.1.1. Push the release lever until it is Presione el embrague hasta que caught by the release stopper.
  • Page 7 Release lever Release stopper 5.2. WARNING: 5.5.2. Push the release lever until it is ƒ When the main switch is set to caught by the release stopper. 1, do not place your fingers near the curl guide or other moving Wire guide Wire parts of the machine!
  • Page 8: Correct Use

    8. Maintenance 45° Arm A Unit 7.1. Correct use 7.1.1. Place the arm A unit in a 45° angle 8.1. Clean and check the RE-BAR tier on over the rebar cross surface and push a regular basis. the mouth towards the rebar. 8.2.
  • Page 9: Troubleshooting

    10.1. Troubleshooting 40 · simasa.com...
  • Page 10 simasa.com · 41...

Table of Contents