Epson EH-LS500W User Manual page 50

Using the Projector on a Network
d
Select the basic options as necessary.
• If your network uses DHCP, set DHCP to On.
• If you are not using DHCP, set DHCP to Off, and then enter the projector's IP Address, Subnet Mask, and
Gateway Address.
e
When you have finished making settings, select Complete and follow the on-screen
instructions to save your settings and exit the menus.
f
Press the source button on the remote control or the [Source] button on the control panel,
and then select LAN.
The settings are complete when you see the correct IP address on the LAN standby screen.
c
To prevent the IP address from being displayed on the LAN standby screen or the Home screen,
set IP Address Display to Off. Network - Network Configuration - Wired LAN
s
49
p.68