Maintenance - Novy 7400/12 Operating And Installation Instructions

Maintenance

Maintenance of the grease filter
The hood contains one or 2 metal filters (according
to the model) which should be cleaned twice a
month.
Access to the filter
Take hold of the right and left side of the plate (a)
an pull down simultaneously. Remove the filter (b)
by taking hold of its hook and by pulling it down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood. Never
use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Replacing the lamps
Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
A. For models with economic lamps
Access to lamps:
• glass plates are attached with clips
• pull down on plates to release from clips
• the lamps can easily be removed from the
socket
• replace lamps
• replace glass plates
The hood has 2 lamps of the following type:
DULUX-L (TC-L) 2G11 / 36 W / color type 830.
Total energy consumption with lightning:
7400, 7210: 240 W
7410, 7220, 7300: 370 W
7405, 7215, 7415, 7225, 7305:
• with 345999: 370 W
• with 445999: 300 W
B. For models with halogen spots
On both sides of the hood 2 halogen lamps are
mounted in a holder. To remove the lamps the
holder needs to be opened.
Opening of the light holder:
• open the plate carefully with both hands
• 2 screws on the holder are visible. Remove
these 2 screws.
• gently slide the holder in the direction of the
filter.
Replace the lamps:
• pull the black socket (with wires) away from
the lamp
• the lamp is held in place by clips, press clips
towards each other and remove from holding
space
• the lamp can now be removed, and a new
lamp can be installed
• install the clips back in their original space
• place socket on lamp
• Place the holder back in his position::
• put holder carefully back in place
• fasten with screws
• close plate
The hood has 4 lamps of the following type:
12V/20W/Ø35/GU4/38°.
EN 16