Replace The Battery Of The Sf61B - Honeywell SF61 User Manual

CHAPTER 4 – TROUBLESHOOT AND MAINTAIN THE SF61B

REPLACE THE BATTERY OF THE SF61B

Note: Integrated circuits on printed circuit boards (PCBs) in this
equipment are sensitive to damage by electrostatic discharge (ESD).
Prevent ESD by always wearing skin contact ground straps firmly
attached to the equipment metal base assembly when working inside of
the equipment housing. Failure to comply may result in damage to PCB
components.
TO CHANGE THE BATTERY
1. Loosen the screw holding the battery cover.
2. Remove the battery cover.
3. Disconnect the battery cable and remove the battery.
4.
Install the new battery:
• Plug in connector.
• Place connector side of battery gently against foam padding.
• Lower the battery into place.
5. Install the battery cover and tighten the screw (56 N cm/4.956 in-lb).
Note: Do not apply excessive pressure to the battery cover when
removing and installing the screw (applying excessive pressure on the
battery cover during removal/installation may damage your product).
44 User's Guide | SF61 Cordless Scanner