Table of Contents
Advertisement
FORCE A SOFTWARE RESET
A software reset of your scanner will reset its parameter settings to their initial values
so you will have to reconfigure any custom settings you have programmed in your
Configure the SF61B Cordless
scanner (see Chapter 3,
TO FORCE A SOFTWARE RESET (RESET FACTORY DEFAULTS) OF
YOUR SF61B
1.
Turn the scanner on by pressing the trigger one time, then release.
Note: You may not be able to tell if the scanner is on, for example if the
LEDs have been disabled and do not light up when you pull the trigger.
2.
Press and hold the scan button for 30 seconds until the red LED comes on.
•
The scanner will beep after 20 seconds (hardware reset); however, keep
the trigger pressed until the red LED comes on (10 more seconds after the
hardware reset).
3.
Press the scan button very rapidly five times in succession while the red LED is on
(you need to be quick as the red LED only stays on for 2 seconds).
•
The green LED comes on, the scanner beeps a reset confirmation (six-beep
melody), and then powers off and powers on (two beeps and vibrate alert by
default).
•
If you had a Bluetooth connection before the software reset, the SF61B will
disconnect from the host device.
Note: Depending on your host configuration (device, Bluetooth version),
after a software reset of your scanner (Reset factory defaults) you may
have to re-pair your product with your host device /application (see the
appropriate section in Chapter 2,
CALL PRODUCT SUPPORT
To talk to a Honeywell Product Support representative:
•
In the U.S.A. and Canada, call 1-800-755-5505.
•
Outside the U.S.A. and Canada, contact your local Honeywell representative.
For help, go to
www.honeywellaidc.com
Before you call Honeywell Product Support, make sure you have the following
information for your SF61B product:
•
configuration number ("CN" on the product label)
•
serial number ("SN" on the product label)
•
firmware version
•
sub-system versions
•
decode version
User's Guide | SF61 Cordless Scanner
CHAPTER 4 –
TROUBLESHOOT AND MAINTAIN THE SF61B
Scanner).
Connect the
SF61B).
and click Contact Us.
GET SF61B VERSION
INFORMATION
There are two ways to get the firmware
version, sub-system versions, and
decode version of your SF61B:
•
Read Get version barcodes
and display your product's
version information on your host
device's screen.
•
Use EasySet in online setup
mode to display your product's
version information.
39
Advertisement
Table of Contents
