Starting And Operating Your Vehicle; Ignition Positions; New Vehicle Break-In - Suzuki Automible 2008 Forenza Owner's Manual

Starting and Operating Your
Vehicle

New Vehicle Break-In

CAUTION
Your vehicle doesn't need an elabo-
rate "break-in." But it will perform
better in the long run if you follow
these guidelines:
• Don't drive at any one speed – fast
or slow – for the first 500 miles (805
km). Don't make full-throttle starts.
• Avoid making hard stops for the
first 200 miles (322 km) or so. Dur-
ing this time your new brake linings
aren't yet broken in. Hard stops
with new linings can mean prema-
ture wear and earlier replacement.
Follow this break-in guideline every
time you get new brake linings.

Ignition Positions

S4U2015A
With the key in the ignition switch, you can
turn the key to four different positions.
WARNING
On manual transmission vehicles,
turning the key to LOCK and remov-
ing it will lock the steering column
and result in a loss of ability to steer
the vehicle. This could cause a colli-
sion. If you need to turn the engine
off while the vehicle is moving, turn
the key only to ACC. Don't push the
key in while the vehicle is moving.
CAUTION
If your key seems stuck in LOCK and
you can't turn it, be sure you are
using the correct key; if so, is it all
the way in? If it is, then turn the steer-
ing wheel left and right while you turn
the key hard. Turn the key only with
your hand. Using a tool to force it
could break the key or the ignition
switch. If none of these works, then
your vehicle needs service.
FEATURES AND CONTROLS
LOCK:
This position locks your steering wheel,
ignition, automatic transmission shift lever
and automatic transmission. This is the
only position from which you can remove
the key. For easier key operation when
unlocking the steering wheel, move the
steering wheel back and forth while turning
the key to the ACC position.
ACC (ACCESSORY):
This position operates some of your elec-
trical accessories, such as the radio, but
not the ventilation fan. Press in the switch
as you turn it away from you.
ON:
This is the position to which the switch
returns after you start your engine and
release the key. The switch stays in ON
when the engine is running. But even when
the engine is not running, you can use ON
to operate your electrical accessories, and
to display some instrument panel warning
lights.
START:
This position starts the engine. When the
engine starts, release the key. The ignition
switch will return to ON for normal driving.
Do not turn the key to START if the engine
is running.
Even if the engine is not running, ACC and
ON allow you to operate electrical acces-
sories, such as the radio.
2-12