Continuously Variable Transaxle (Cvt) Fluid - Suzuki 2010 SX4 Sedan Owner's Manual

Continuously Variable
Transaxle (CVT) Fluid
Specified Fluid
Use a CVT fluid SUZUKI CVT FLUID
GREEN-1 or Shell GREEN-1V.
Fluid Level Check
CAUTION
Driving with too much or too little
fluid can damage the transaxle.
You must check the fluid level with the CVT
fluid at normal operating temperature.
To check the fluid level:
1) To warm up the transaxle fluid, drive the
vehicle or idle the engine until the tem-
perature gauge indicates normal oper-
ating temperature.
2) Then drive for ten more minutes.
CAUTION
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-1 or Shell
GREEN-1V may damage the CVT of
your vehicle.
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indica-
tion will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in "P" (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal, move
the gearshift lever through each gear,
pausing for about three seconds in
each range. Then move it back to the
"P" (Park) position.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
EXAMPLE
INSPECTION AND MAINTENANCE
EXAMPLE
EXAMPLE
(3)
(2)
(1) FULL
(2) LOW
(3) The lowest point = Fluid level
75F086
80J2071
(1)
80J2072
7-20
80J23-03E