Table of Contents
Advertisement
Guidelines on electrical
connections
Shielding application
Switching output
12
BA 35
Schaeffler GreaseCheck
Any work on wiring, opening or closing of electrical connections
may only be performed while disconnected from the power supply
and in a voltage-free state.
During mounting, ensure that the cables are not subjected to any
mechanical tensile load. If necessary, take measures to relieve
the tensile load.
Observe the minimum permissible bending radii of the cables.
These are stated in the manufacturer's data sheets. For cables
included in the standard accessories for Schaeffler Technologies
AG & Co. KG, the minimum recommended bending radius is 59 mm.
Mount the cables such that they are firmly laid and cannot flap.
Do not lay signal cables parallel with lines carrying high currents.
■
The shielding must always be applied over an extensive area to
the EMC shielding plates on the switch cabinet side and fully over
the connection plug of the electronic evaluation system.
■
Do not trim the shielding after the application point but continue
it as far as the connection terminals.
■
CAN bus
If a CAN bus is not used, the CAN bus must be applied to unwired
terminals with zero potential.
■
If a switching output is not used, the switching output must be
applied to an unwired terminal with zero potential.
Schaeffler Technologies
Advertisement
Table of Contents
