Advertisement
INSTALLATION INSTRUCTIONS
S
I
AFETY
NSTRUCTIONS
!
WARNING:
Before starting installation, read and understand all safety label and warnings on the machine. Also review and
understand all safety instructions in the owners, installation and service manuals.
Failure to comply could result in serious injury, death or damage to the equipment.
Q
S
UALIFIED
ERVICE
!
WARNING:
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit.
All wiring and plumbing must conform to national and local codes. Failure to comply could
result in serious injury, death or equipment damage.
S
P
AFETY
RECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued
protection observe the following:
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all
power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
!
CAUTION:
Always be sure to keep area around the unit clean and free of clutter.
Failure to keep this area clean may result in injury or equipment damage.
Revision Date: July 12, 2016
© 2016, Cornelius Inc.
ED A
K
DAPTER
IT
P
ERSONNEL
www.cornelius.com
ED Ice Maker Adapter Kit Installation Instructions Manual
F
F
I
OR
OLLETT
CEMAKERS
- 1 -
Revision: A
Publication Number: 629087971TENS
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cornelius ED
Summary of Contents for Cornelius ED
- Page 1 ED Ice Maker Adapter Kit Installation Instructions Manual INSTALLATION INSTRUCTIONS ED A DAPTER OLLETT CEMAKERS AFETY NSTRUCTIONS WARNING: Before starting installation, read and understand all safety label and warnings on the machine. Also review and understand all safety instructions in the owners, installation and service manuals.
- Page 2 ED Ice Maker Adapter Kit Installation Instruction Manual 1. Remove the plastic hopper lid(s) from the top of the dispenser. 2. Install soft ice agitator kit (sold separately) into the dispenser. NOTE: This soft ice agitator kit is required for proper dispenser operation using “compressed” or “soft”...
- Page 3 ED Ice Maker Adapter Kit Installation Instructions Manual 6. Remove merchandiser from dispenser by lifting up then pulling out. Set merchandiser aside. 7. Adjust the automatic agitator timing settings (located in the dispenser’s electrical box) to 2 seconds ON, 3 hours OFF.
- Page 4 THESE DIMENSIONS ARE TO AID IN INSTALLATION. ACTUAL LOCATION MAY VARY. Figure 5. ED/DF300 NOTE: FOR ED/DF300 ONLY - Be sure to center the ice drop opening of the Icemaker directly over the deflector plate. Failure to do so may result in un-even hopper fill.
- Page 5 ED Ice Maker Adapter Kit Installation Instructions Manual 13. Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent) to seal the ice maker to the top of the adapter lid. All excess sealant must be wiped away immediately.
Need help?
Do you have a question about the ED and is the answer not in the manual?
Questions and answers