Advertisement
VAN1LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
MOUNTING TO THE OPTIONAL
VAN1BB BACK BOX
1. Attach conduit to desired conduit entrance(s) in VAN1
BB Back Box.
2. Loosen Tamperproof Screws to remove Refractor
from Mounting Plate.
3. Secure Back Box to surface using proper hardware.
4. Feed supply lines through Mounting Plate
Gasket and Back Box and make necessary wiring
connections.
5. Align Mounting Plate with Mounting Plate Gasket
and secure to Back Box by tightening O-Ring and
1/4-20 Bolt into offset hole in Mounting Plate.
6. Secure Refractor back onto Mounting Plate by
tightening provided Tamperproof Screws.
VAN1 BB
Back Box
Supply
Wires
O-Ring and
1/4-20 Bolt
Refractor
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
Easy Installation & Product Help
Tech Help Line
©2016 RAB LIGHTING Inc.
Call our experts 888 RAB-1000
Northvale, New Jersey 07647 USA
VAN1LED-IN-1016
Mounting
Plate Gasket
Mounting
Plate
AC Board
Tamperproof
Screws
rabweb.com
Visit our website for product info
WIRING
USE SUPPLY WIRE RATED FOR 90ºC.
1. Connect the line (+) fixture lead to the black supply lead.
2. Connect the common (-) fixture lead to white supply lead.
3. Connect the GROUND wire from fixture to supply ground.
4. All unused leads must be capped and insulated.
TAMPERPROOF SCREWS
RAB Vandalproof fixtures are shipped with both standard
and tamperproof screws. For maximum security, insert
tamperproof screws into the refractor and tighten with
Center Pin Torx Screwdriver. (Catalog # Vandriver, not
supplied)
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Be sure the fixture is grounded properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean polycarbonate lens with non-abrasive cleaning
solution.
2. Do not open the fixture to clean the LEDs. Do not touch
the LEDs.
email
Answered promptly sales@rabweb.com
Advertisement
