Page 1
2-Speed Hammer Drill HP2000 HP2020 SPECIFICATIONS Model HP2000 HP2020 Speed High High Concrete 20 mm – 20 mm – Capacities Steel 6.5 mm 13 mm 6.5 mm 13 mm –1 No load speed (min 0 – 2,300 0 – 900...
Page 3
END201-5 Symbols The following show the symbols used for the equipment. Be sure that you understand their meaning before use. • Read instruction manual. • DOUBLE INSULATION • Only for EU countries Do not dispose of electric equipment together with household waste material! In observance of European Directive 2002/96/EC on waste electric and electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility.
ENGLISH (Original instructions) Explanation of general view Change ring Change lever Chuck key Switch trigger High Tighten Lock button 10 Speed control screw Depth gauge ENE039-1 If operating a power tool in a damp location is Intended use unavoidable, use a residual current device (RCD) The tool is intended for impact drilling in brick, concrete protected supply.
Do not leave the tool running. Operate the tool Switch action (Fig. 8) only when hand-held. For HP2000 Do not touch the bit or the workpiece immedi- To start the tool, simply pull the trigger. Tool speed is ately after operation; they may be extremely hot increased by increasing pressure on the trigger.
• Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product safety and reliability, repairs, mainte- nance or adjustment should be carried out by Makita Authorized Service Center.
Page 8
Makita Corporation Anjo, Aichi, Japan www.makita.com 884211B3...